Differences

This shows you the differences between two versions of the page.

--- hambasics:sections:wavemodulation [2026/07/10 09:48] – [Activity] va7fi
+++ hambasics:sections:wavemodulation [2026/07/10 10:00] (current) – va7fi
@@ Line 143: / Line 143: @@
 There are three things to notice here:
-  * The two side bands are 10 kHz on each side of the carrier (same as the <fc #ff0000>baseband</fc> signal!).  It is that distance away from the carrier that represents the audio signal we want to recover.
+  * The two side bands are 10 kHz on each side of the carrier (<wrap hi>same as the <fc #ff0000>baseband</fc> signal!</wrap>).  It is that distance away from the carrier that represents the audio signal we want to recover.
   * Most of the power is going into transmitting the carrier, which in itself doesn't carry any information, so that's a bit of a waste of energy.
   * More fundamentally: even though we say that the signal is transmitted at 200 kHz, in this example, it is really contained between 190 kHz and 210 kHz.  That is, it has a bandwidth of 20 kHz (210 kHz - 190 kHz).  This bandwidth is regulated and depends on the [[intro#full_frequency_list| band used]].
@@ Line 195: / Line 195: @@
 ^Bandwidth |About 2.7 kHz on the low side of 3.875 MHz |About 6 kHz (2.7 kHz on each side of 3.885 MHz, with two gaps near the carrier) |
 ^Pauses |During pauses, no radio signal is transmitted. |During pauses, the carrier is still transmitted. |
+^^^
 ^Relationship |An AM signal can be understood in LSB mode because it contains the lower side band required.  But an LSB signal can't be understood in AM mode because both sidebands and the carrier are needed to process the signal.    ||