Patrick installed a Mikrotik LDF-5 (the n model, not the ac model) on a used TELUS satellite TV dish.

• The first task was to mount the LDF-5 to the dish roughly where the old receiver was. Unfortunately, the arm and the LDF-5 mounting bracket were both a bit too short so the LDF-5 was too close to the dish and too low:
  
  

• So a second arm was bolted on top of the first to raise the LDF-5 and move it a bit further away:
  
  

• Initially, the dish was mounted on a post with a 45° angle, but after field testing it, it was found to be unnecessary and a vertical post will be used next time.
  
  

On July 4, 2021, Chris (VE7TOP) and Patrick (VA7FI) made a successful connection on 5.860 GHz (Ch. 172) between Nanaimo (49.227263, -123.975836) and Roberts Creek (49.45465, -123.64199): a distance of 35 km.

• Here's Patrick's setup and the view from the dish. The red circle marks the spot where Chris is. The log periodic was for VHF communications between Chris and Patrick to perform the adjustments.
  
  

• Here are Patrick's settings:
  

• For the first test, Chris used a dish (: add details). After adjusting the dish's directions and elevations, the best signal strength received by Patrick was above -60dBm (which is pretty impressive!) with an SNR of over 35dB:
  
  
  

• For the second test, Chris switched to a 120° sector antenna (: add details). Here, the best signal strength received by Patrick was a bit above 80dBm with with an SNR of about 17dB:
  
  
  

These two tests show that it is possible to establish a connection between Nanaimo and the Sunshine Coast. The 120° sector antenna might be pushing it a little bit, but a 45° sector antenna would be enough to cover Gibsons through Sechelt and would offer an additional 6dB of gain over the 120° sector antenna.

Today I managed to install my AREDN dish up the tree, run the CAT5 to the house, and connect it to the hAP. I started working at 7:45 this morning and finished around 5pm (after climbing up and down three times).

I aimed the dish roughly towards Mount Benson (222°), but unfortunately, I didn't manage to make a connection to the node there. I'll try and go back up tomorrow to see if I can find the correct bearing now that the node is powered up, but I'm done for today.

Yesterday, the folks on the Island went back to Mount Benson and adjusted the tilt on their antennas. After the adjustment, I started getting an intermittent signal. So today, I went back up the tree and used that signal to fine-tune the adjustment of my dish and managed to squeeze an extra 5-10 dB! Here's a graph of the signal before, during, and after the adjustment:

Unfortunately, it looks like I can hear the Mount Benson node 6-7 dB more strongly than it can hear me. I'm transmitting at 25 dBm (≈315 mW). I don't know what their node's power is, but I'm guessing it's a little more than mine.

Here's the status report pages for both nodes. It looks like I might be able to reach 1.6 mbps, which is pretty impressive compared to VHF packet, but still pretty slow compared to the other stations.