howto:band_scope
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
2020-04-22:band_scope [2020/07/17 07:46] – ↷ Page moved from blog:2020-04-22:band_scope to 2020-04-22:band_scope va7fi | howto:band_scope [2020/07/17 07:47] – ↷ Page moved from 2020-04-22:band_scope to howto:band_scope va7fi | ||
---|---|---|---|
Line 11: | Line 11: | ||
One thing I always found a bit annoying about the IC-7300 is that when in Single Side Band mode, the display shifts the frequency a bit so that the centre of the signal is shown at the display frequency. | One thing I always found a bit annoying about the IC-7300 is that when in Single Side Band mode, the display shifts the frequency a bit so that the centre of the signal is shown at the display frequency. | ||
- | {{ : | + | {{ howto:scope1.png }} |
Note that even though it's an LSB signal, the centre of the signal is at 7.100 MHz. I don't like this for two reasons: | Note that even though it's an LSB signal, the centre of the signal is at 7.100 MHz. I don't like this for two reasons: | ||
Line 19: | Line 19: | ||
Instead, I'd like the display to show this: | Instead, I'd like the display to show this: | ||
- | {{ : | + | {{ howto:scope2.png }} |
As it turns out, there' | As it turns out, there' | ||
<WRAP centeralign> | <WRAP centeralign> | ||
- | {{: | + | {{howto: |
</ | </ | ||
- Press and hold the '' | - Press and hold the '' |
howto/band_scope.txt · Last modified: 2020/10/07 08:30 by va7fi