Differences

This shows you the differences between two versions of the page.

--- 2020-04-22:band_scope [2020/07/17 07:46] – ↷ Page moved from blog:2020-04-22:band_scope to 2020-04-22:band_scope va7fi
+++ howto:band_scope [2020/10/07 08:01] – ↷ Links adapted because of a move operation va7fi
@@ Line 1: / Line 1: @@
+~~NOTOC~~
 ====== Band Scope ======
-In the [[/howto/hambasics/wavemodulation#modulation |Modulation section]] of the (still under construction) Ham Basics page, I show this screen capture of my IC-7300 to illustrate the difference between AM and Single Side Band signals:
+In the [[howto:hambasics:sections:wavemodulation#modulation|Modulation section]] of the (still under construction) Ham Basics page, I show this screen capture of my IC-7300 to illustrate the difference between AM and Single Side Band signals:
 {{  howto/hambasics/scope01.png  }}
@@ Line 11: / Line 12: @@
 One thing I always found a bit annoying about the IC-7300 is that when in Single Side Band mode, the display shifts the frequency a bit so that the centre of the signal is shown at the display frequency.  Here's an example of an LSB signal on the Aurora Net on 7.100 MHz:
-{{ :blog:2020-04-22:scope1.png }}
+{{ howto:scope1.png }}
 Note that even though it's an LSB signal, the centre of the signal is at 7.100 MHz.  I don't like this for two reasons:
@@ Line 19: / Line 20: @@
 Instead, I'd like the display to show this:
-{{ :blog:2020-04-22:scope2.png }}
+{{ howto:scope2.png }}
 As it turns out, there's an easy (but a bit hidden) way to switch this setting:
 <WRAP centeralign>
-{{:blog:2020-04-22:settings1.png?280}} {{:blog:2020-04-22:settings2.png?280}} {{:blog:2020-04-22:settings3.png?280}}
+{{howto:settings1.png?280}} {{howto:settings2.png?280}} {{howto:settings3.png?280}}
 </WRAP>
   - Press and hold the ''EXPD/SET'' button on the screen.