howto:hambasics:b003
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
howto:hambasics:b003 [2019/11/27 19:59] – [Questions] ve7hzf | howto:hambasics:b003 [2020/02/20 19:04] – [Transmitters] va7fi | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | <box orange | + | |<100% ----- >| |
- | '' | + | | [[home |Ham Basics]] |
- | </box> | + | |
+ | <WRAP round todo center box 60%> | ||
+ | **Under Construction**: VA7FI is editing this section, please do not edit it until this notice is taken down. | ||
+ | </WRAP> | ||
====== Station Assembly, Practice and Safety ====== | ====== Station Assembly, Practice and Safety ====== | ||
+ | |||
+ | ===== Block Diagrams ===== | ||
+ | The next few sections use block diagrams to illustrate the configuration of various pieces of equipment. | ||
+ | |||
+ | {{ youtube> | ||
===== HF Station ===== | ===== HF Station ===== | ||
Line 22: | Line 30: | ||
All that being said, it's possible to go on HF with a transceiver that has an small integrated tuner in it, and a single antenna. | All that being said, it's possible to go on HF with a transceiver that has an small integrated tuner in it, and a single antenna. | ||
- | ===== To Review | + | ===== Transmitters |
+ | <WRAP round info box center 80%> | ||
+ | **Review** the [[wavemodulation |Wave Modulation]] page. You should: | ||
+ | * understand the difference between the // | ||
+ | * understand the difference between //AM// and //FM//. | ||
+ | </ | ||
- | <box blue 80%> | ||
- | For the next few sections, review the [[wavemodulation |Wave Modulation]] page. You should understand: | ||
- | * the difference between the // | ||
- | * the difference between //AM// and //FM//. | ||
- | </ | ||
- | ===== FM Transmitter ===== | + | ==== CW Transmitter ==== |
+ | {{ : | ||
+ | * The **master oscillator** generates a stable sine wave signal at the rest frequency. | ||
+ | * The **driver / buffer** is the first stage in the amplification process. | ||
+ | * The **key** is basically an on/off switch used to let the signal through to the amplifier or block it. | ||
+ | * The **power amplifier** is the last stage of amplification before the signal is released to the antenna. | ||
+ | |||
+ | |||
+ | ==== FM Transmitter ==== | ||
{{ : | {{ : | ||
Line 40: | Line 56: | ||
* The **frequency multiplier** increases the frequency of the modulated signal by a factor of 2, 3, or 4. This is so that the oscillator frequency can be lower than the frequency transmitted at the antenna. | * The **frequency multiplier** increases the frequency of the modulated signal by a factor of 2, 3, or 4. This is so that the oscillator frequency can be lower than the frequency transmitted at the antenna. | ||
* The **amplifier** increases the power of the signal to be transmitted by the antenna. | * The **amplifier** increases the power of the signal to be transmitted by the antenna. | ||
- | ===== FM Receiver ===== | + | |
+ | |||
+ | ==== SSB Transmitter ==== | ||
+ | {{ : | ||
+ | |||
+ | * The **microphone** picks up the sound waves carried by the air and converts them into a weak electrical signal that becomes the // | ||
+ | * The **speech amplifier** increases the strength of the baseband signal before it can modulate the carrier. | ||
+ | * The **RF oscillator** generates a stable sine wave signal at the rest frequency. Note that the oscillator frequency can be much lower than the final transmitted frequency. | ||
+ | * The outputs of the speech amplifier and the RF oscillator are mixed together in the **balanced modulator**. This produces a signal with two side bands, only one of which we want to keep. | ||
+ | * The **filter** only lets one sideband through. | ||
+ | * The **VFO** creates a sine wave frequency that can be varied. | ||
+ | * The **mixer** uses the output from the filter and the VFO to generate a higher frequency signal. | ||
+ | * The **linear amplifier** increases the power of the signal to be transmitted by the antenna. | ||
+ | |||
+ | <WRAP important center round 80%> | ||
+ | Note that a [[wp> | ||
+ | </ | ||
+ | |||
+ | ===== Receivers ===== | ||
+ | |||
+ | ==== FM Receiver ==== | ||
+ | Before we look at individual components, there' | ||
{{ : | {{ : | ||
- | Before we look at individual components, it's important to highlight an important trick: The received radio frequency (RF) is converted down to a predetermined intermediate frequency (IF) before being processed further. | ||
* The **RF amplifier** increases the strength of the weak radio signal received by the antenna. | * The **RF amplifier** increases the strength of the weak radio signal received by the antenna. | ||
Line 52: | Line 89: | ||
* The **frequency discriminator** extracts the baseband signal. | * The **frequency discriminator** extracts the baseband signal. | ||
* The **audio amplifier** increases the strength of the baseband signal before passing it to the speaker. | * The **audio amplifier** increases the strength of the baseband signal before passing it to the speaker. | ||
- | ====== CW Transmitter ====== | ||
- | {{ : | ||
- | ====== SSB/CW Receiver | + | |
+ | ==== SSB/CW Receiver ==== | ||
{{ : | {{ : | ||
+ | ===== Digital System ===== | ||
+ | {{ : | ||
+ | |||
+ | |||
+ | ===== Regulated Power Supply ===== | ||
+ | {{ : | ||
====== Questions ====== | ====== Questions ====== | ||
* B-003-001-001 -> B-003-003-010 | * B-003-001-001 -> B-003-003-010 | ||
- | [[sections | + | [[propagation |