Sun Coast Amateur
Radio Club Society

User Tools

Site Tools

You are here: home » howto » hambasics » b003
howto:hambasics:b003

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
howto:hambasics:b003 [2019/12/17 19:58] – va7fihowto:hambasics:b003 [2020/02/20 19:04] – [Transmitters] va7fi
Line 1: Line 1:
 +|<100% ----- >|
 +|  [[home |Ham Basics]]  |  [[test |About The Test]]  |  [[Reference |References]]  ^  [[sections |Study Sections]]  |
 +
 <WRAP round todo center box 60%> <WRAP round todo center box 60%>
  **Under Construction**: VA7FI is editing this section, please do not edit it until this notice is taken down.  **Under Construction**: VA7FI is editing this section, please do not edit it until this notice is taken down.
Line 6: Line 9:
  
 ===== Block Diagrams ===== ===== Block Diagrams =====
-The next few sections use block diagram to illustrate the construction of various pieces of equipment.  Here's an excellent introduction that should help with what follows:+The next few sections use block diagrams to illustrate the configuration of various pieces of equipment.  Here's an excellent introduction that should help with what follows:
  
 {{ youtube>3VXnhIeeT6c }} {{ youtube>3VXnhIeeT6c }}
Line 45: Line 48:
  
 ==== FM Transmitter ==== ==== FM Transmitter ====
- 
 {{ :howto:hambasics:3_2.png }} {{ :howto:hambasics:3_2.png }}
  
Line 59: Line 61:
 {{ :howto:hambasics:3_6.png }} {{ :howto:hambasics:3_6.png }}
  
 +  * The **microphone** picks up the sound waves carried by the air and converts them into a weak electrical signal that becomes the //baseband//.
 +  * The **speech amplifier** increases the strength of the baseband signal before it can modulate the carrier. 
 +  * The **RF oscillator** generates a stable sine wave signal at the rest frequency. Note that the oscillator frequency can be much lower than the final transmitted frequency. 
 +  * The outputs of the speech amplifier and the RF oscillator are mixed together in the **balanced modulator**. This produces a signal with two side bands, only one of which we want to keep.
 +  * The **filter** only lets one sideband through.
 +  * The **VFO** creates a sine wave frequency that can be varied.
 +  * The **mixer** uses the output from the filter and the VFO to generate a higher frequency signal.
 +  * The **linear amplifier** increases the power of the signal to be transmitted by the antenna.
 +
 +<WRAP important center round 80%>
 +Note that a [[wp>Frequency_mixer |Frequency Mixer]] //multiplies// two signals together, which usually results in a total of four (or more) frequencies.  This is not to be confused with an [[wp>Mixing_console |Audio Mixer]], which //adds// different signals together.  See the optional [[wavemodulationmath#mixer | Wave Modulation Math page]] for more details.
 +</WRAP>
  
 ===== Receivers ===== ===== Receivers =====
- 
-==== SSB/CW Receiver ==== 
-{{ :howto:hambasics:3_5.png }} 
- 
  
 ==== FM Receiver ==== ==== FM Receiver ====
Line 80: Line 90:
   * The **audio amplifier** increases the strength of the baseband signal before passing it to the speaker.   * The **audio amplifier** increases the strength of the baseband signal before passing it to the speaker.
  
 +
 +
 +==== SSB/CW Receiver ====
 +{{ :howto:hambasics:3_5.png }}
  
 ===== Digital System ===== ===== Digital System =====
Line 91: Line 105:
   * B-003-001-001 -> B-003-003-010   * B-003-001-001 -> B-003-003-010
  
-[[sections |{{/back.png }}]] [[waveinterference |{{  /next.png}}]]+[[propagation |{{/back.png }}]] [[section |{{  /next.png}}]]