howto:hambasics:b003
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
howto:hambasics:b003 [2019/12/23 09:10] – ve7hzf | howto:hambasics:b003 [2020/02/20 19:04] – [Transmitters] va7fi | ||
---|---|---|---|
Line 9: | Line 9: | ||
===== Block Diagrams ===== | ===== Block Diagrams ===== | ||
- | The next few sections use block diagram | + | The next few sections use block diagrams |
{{ youtube> | {{ youtube> | ||
Line 48: | Line 48: | ||
==== FM Transmitter ==== | ==== FM Transmitter ==== | ||
- | |||
{{ : | {{ : | ||
Line 62: | Line 61: | ||
{{ : | {{ : | ||
+ | * The **microphone** picks up the sound waves carried by the air and converts them into a weak electrical signal that becomes the // | ||
+ | * The **speech amplifier** increases the strength of the baseband signal before it can modulate the carrier. | ||
+ | * The **RF oscillator** generates a stable sine wave signal at the rest frequency. Note that the oscillator frequency can be much lower than the final transmitted frequency. | ||
+ | * The outputs of the speech amplifier and the RF oscillator are mixed together in the **balanced modulator**. This produces a signal with two side bands, only one of which we want to keep. | ||
+ | * The **filter** only lets one sideband through. | ||
+ | * The **VFO** creates a sine wave frequency that can be varied. | ||
+ | * The **mixer** uses the output from the filter and the VFO to generate a higher frequency signal. | ||
+ | * The **linear amplifier** increases the power of the signal to be transmitted by the antenna. | ||
+ | |||
+ | <WRAP important center round 80%> | ||
+ | Note that a [[wp> | ||
+ | </ | ||
===== Receivers ===== | ===== Receivers ===== | ||
- | |||
- | ==== SSB/CW Receiver ==== | ||
- | {{ : | ||
- | |||
==== FM Receiver ==== | ==== FM Receiver ==== | ||
Line 83: | Line 90: | ||
* The **audio amplifier** increases the strength of the baseband signal before passing it to the speaker. | * The **audio amplifier** increases the strength of the baseband signal before passing it to the speaker. | ||
+ | |||
+ | |||
+ | ==== SSB/CW Receiver ==== | ||
+ | {{ : | ||
===== Digital System ===== | ===== Digital System ===== | ||
Line 94: | Line 105: | ||
* B-003-001-001 -> B-003-003-010 | * B-003-001-001 -> B-003-003-010 | ||
- | [[sections | + | [[propagation |