Differences

This shows you the differences between two versions of the page.

--- howto:signalink [2023/10/18 17:44] – [Initial Software Configuration] va7fi
+++ howto:signalink [2023/11/09 15:53] (current) – va7fi
@@ Line 1: / Line 1: @@
-~~NOTOC~~
 ====== SignaLink USB ======
@@ Line 77: / Line 75: @@
     * Select the ''No Sounds'' scheme and do not Play Windows Startup sound.  This will ensure that Windows sounds don't get transmitted over the air.
-  * Optionally, double click on the "USB AUDIO CODEC" and select the "Listen" tab and check the "Listen to this device" box to hear the radio through the computer's "Default Playback Device".
+  * Optionally, double click on the ''USB AUDIO CODEC'' and select the ''Listen'' tab and check the ''Listen to this device'' box to hear the radio through the computer's ''Default Playback Device''.
 {{  :howto:signalink:lineproperties.png  }}
@@ Line 113: / Line 111: @@
   * Output volume calibration.  The idea here is that you want to transmit the loudest volume possible without over driving and distorting the signal.  In general, there's three different volumes to adjust: the computer's output, the radio's microphone gain, and the SignaLink Tx Volume.
-    * Start by setting the Windows output volume to 50%.  FIXME
+    * Start by setting the Windows output volume to 50% (''Open Sound settings'' -> ''Sound Control Panel'' -> ''Recording'' -> double click on ''Signalink'' -> ''Levels''
-    * and the Radio's microphone gain to 2 (''Settings'' -> FIXME)
+    * and the Radio's microphone gain to 2
     * To adjust the Signalink Tx Volume:
       * Select a simplex frequency not in use, and identify using your microphone to let other potential operators know of your intention to conduct a brief test.