User Tools

Site Tools


howto:winlink_ardop

This is an old revision of the document!


Winlink ARDOP

Winlink ARDOP is a method of sending “email” messages over HF radio via an RMS station (see the Winlink How-To for more info). It is very similar to Winmor, but the latter has been deprecated.

Every week, I connect to RMS stations in different locations and keep a log so I can track the most reliable ones. Here's the scenario I'm considering and how I'd use my log.

The Scenario

In the event of an emergency where the power and all communications go down, I want to be able to send my family back east a quick email to let them know that I'm ok, and offer the same service to others in my neighbourhood.

Radio Check

Every week, I connect to RMS stations in different locations without actually sending or receiving messages just to see how long the “handshake” takes and to see if I can connect at all.

I save the successful connections to my Winlink favourites for quick retrieval, but I also log them in a spreadsheet that I continuously analyze.

The Spreadsheet

The Winlink favourites list is an excellent tool, but it's hard to “rank” the best stations. To that end, I use a spreadsheet to log the following information in addition to the stations' information:

  • The length of the session (the shorter the better).
  • The date I last managed a connection (the most recent the better)
  • The number of times I managed a connection (the bigger the better)

I then “rank” the distance (the further away the better since our local emergency might not affect them if they're further away), and the bearing (inland is better assuming we get an Earthquake and/or Tsunami). Based on all these different rankings, I created a semi-subjective “top 5” ranking of the stations. Those are the stations I would try to connect to first.

The purpose of this spreadsheet is to do the “thinking” ahead of time so that in a real emergency, I can just look at the ranking to select the best frequency.

Ardop, Vara, Pactor

There's essentially four different methods for sending Winlink messages on HF:

  • Pactor is the fastest / most robust method but it requires a $2100 external modem to work.
  • Winmor is has been deprecated and will probably be removed from later versions of Winlink. It has a maximum speed of 750 bps.
  • Ardop is the method I use. It is an open protocol in active development and has a maximum speed of 1336 bps. See here for an overview.
  • Vara is a closed protocol. The demo version has a maximum speed of 175 bps and the full version ($70 USD) has a maximum speed of 7536 bps. See here for more details.

So which is best to use? Well, it depends... For P2P, it's important that everyone uses the same method (and frequency), but for messages sent via an RMS, it doesn't matter at all.

What is best for a local EOC?

Our local EOC reports to the SW PREOC in Surrey and their website says:

<WRAP indent> The preferred method is data rather than voice. If you cannot get through peer to peer, send the message via Winlink.

It then goes on to list HF Data frequencies but doesn't say which mode to use (as if that was obvious). But our local EOC has a Pactor modem so I assume that's the industry standard. But that only matters for P2P. For Winlink messages sent to an RMS will make it to their destination no matter the method.

So for EOCs, the answer seems to be the current standard: Pactor

What is best for individuals?

Again, unless you want to use P2P, it doesn't matter if people are using different methods. Both Ardop and the free version of Vara seem to work, although the demo version of Vara also has an annoying pop up screen every few minutes asking you to register.1)

Conclusion

I understand the desire for standardization within a region. It would be nice if there was only one (best) mode (and it was free), but given all the different options, I guess it's a trade-off between cost, community by-in, and speed.

Personally, I can't justify spending $100 from my limited ham radio fund just to get a Winlink speed upgrade. If the option was between having HF Winlink for $100, or no HF Winlink at all, I would spend the money, but $100 for a mere speed upgrade is below my diminishing returns threshold. There's a lot of more I could do to improve my station with that money.

The other thing to consider is that if Vara figured out a way to increase the speed in a closed-proprietary way, it's just a matter of time before the Open Source Ardop team catches up. Personally, I tend to favour open source options to closed proprietary ones not only because it's cheaper for myself, but also because it lowers the entry bar for others in the community to join. If HF P2P is really important for our community, then we probably don't want to exclude people who can't afford the $100 entrance fee.

howto/winlink_ardop.1602876043.txt.gz · Last modified: 2020/10/16 12:20 by va7fi