blog:2021-01-30:atu-100_project
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
blog:2021-01-30:atu-100_project [2021/03/06 08:26] – va7ilo | blog:2021-01-30:atu-100_project [2021/03/10 20:07] – va7ilo | ||
---|---|---|---|
Line 67: | Line 67: | ||
Another note on these ferrites is to make sure you strip or sand off the insulation far enough up so that it is bare on the top side of the board, these are double sided PCBs so the solder needs to flow to the other side to solder to the top pads too. | Another note on these ferrites is to make sure you strip or sand off the insulation far enough up so that it is bare on the top side of the board, these are double sided PCBs so the solder needs to flow to the other side to solder to the top pads too. | ||
+ | |||
+ | |||
+ | {{: | ||
+ | |||
+ | Here is one of the ATUs so far. | ||
blog/2021-01-30/atu-100_project.txt · Last modified: 2021/03/10 20:10 by va7ilo