Differences

This shows you the differences between two versions of the page.

--- howto:winlink_ardop [2020/10/26 22:46] – va7fi
+++ howto:winlink_ardop [2021/06/06 10:17] – va7fi
@@ Line 85: / Line 85: @@
 Our local EOC reports to the SW PREOC in Surrey and [[http://www.percs.bc.ca/?page_id=10 |their website]] says:
-<WRAP indent>
+<QUOTE>The preferred method is data rather than voice. If you cannot get through peer to peer, send the message via Winlink.>>
-<<The preferred method is data rather than voice. If you cannot get through peer to peer, send the message via Winlink.>>
+</QUOTE>
-</WRAP>
 It then goes on to list HF Data frequencies but doesn't say which mode to use (as if that was obvious).  But our local EOC has a Pactor modem so I assume that's the industry standard.  But that only matters for P2P. Winlink messages sent to an RMS will make it to their destination no matter the method.
@@ Line 96: / Line 95: @@
 ==== What is best for individuals? ====
-Again, unless you want to use P2P, it doesn't matter if people are using different methods.  Both Ardop and the free version of Vara seem to work, although the demo version of Vara also shows an annoying popup screen every few minutes asking you to register.((Vara shows an annoying popup screen every few minutes. \\ {{howto:vara.png?300}}))
+Again, unless you want to use P2P, it doesn't matter if people are using different methods.  Both Ardop and the free version of Vara seem to work, although the demo version of Vara also shows an annoying popup screen every few minutes asking you to register.((Vara shows an annoying popup screen every few minutes. \\ {{howto:vara.png?400}}))
 ==== Conclusion ====