Sun Coast Amateur
Radio Club Society

User Tools

Site Tools

You are here: home » howto » winlink_ardop
howto:winlink_ardop

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
howto:winlink_ardop [2020/10/26 22:46] – va7fihowto:winlink_ardop [2021/06/06 10:17] – va7fi
Line 85: Line 85:
 Our local EOC reports to the SW PREOC in Surrey and [[http://www.percs.bc.ca/?page_id=10 |their website]] says: Our local EOC reports to the SW PREOC in Surrey and [[http://www.percs.bc.ca/?page_id=10 |their website]] says:
  
-<WRAP indent> +<QUOTE>The preferred method is data rather than voice. If you cannot get through peer to peer, send the message via Winlink. 
-<<The preferred method is data rather than voice. If you cannot get through peer to peer, send the message via Winlink.>> +</QUOTE>
-</WRAP>+
  
 It then goes on to list HF Data frequencies but doesn't say which mode to use (as if that was obvious).  But our local EOC has a Pactor modem so I assume that's the industry standard.  But that only matters for P2P. Winlink messages sent to an RMS will make it to their destination no matter the method. It then goes on to list HF Data frequencies but doesn't say which mode to use (as if that was obvious).  But our local EOC has a Pactor modem so I assume that's the industry standard.  But that only matters for P2P. Winlink messages sent to an RMS will make it to their destination no matter the method.
howto/winlink_ardop.txt · Last modified: 2023/10/24 22:40 by va7fi